3H-5593-06 – Low Pressure Hoses
3H-5593-06 – Low Pressure Hoses
3H-5593-06

3H-5593-06 – Low Pressure Hoses

Print Icon Print Download Icon Download PDF

Specification

  • Construction: A. Inner Tube: Oil And Fuel Resistant Synthetic Compound. B. Reinforcement: Single Cotton Braid Embedded In Bonding Material. C. Outer Cover: Oil And Fuel Resistant Synthetic Compound.
  • Hose Size: 3/8
  • Weight Lbs Per Ft: 0.094
  • Identification: Black Cover With Yellow Dot And Dash Stripe Running Parallel To Bore Of Hose To Indicate Natural Lay Of Hose After Installing. The Letters Lp In The Stripe Indicate Low Pressure. The Specificat
  • Id In: 0.375
  • Max Od In: 0.625
  • Max Working Pressure: 150
  • Mil Spec: Mil-Dtl-5593
  • Min Bend Radius : 2
  • Min Burst Pressure: 1
  • Operating Systems: A. Severe Vibrating And Flexing. B. Resistant To Engine Oil And Cleaning Solvent Externally. C. Internal And External Temperatures From -67ºf To +158ºf. D. Internal Fluids
  • Proof Test Pressure Psi: 300
  • Size No: 06
  • Notes: Dimensional Information Is For Reference Only. Variations From These Dimensions On Actual Parts May Occur As The Result Of Engineering Revisions.

Specification Table

ConstructionA. Inner Tube: Oil And Fuel Resistant Synthetic Compound. B. Reinforcement: Single Cotton Braid Embedded In Bonding Material. C. Outer Cover: Oil And Fuel Resistant Synthetic Compound.
Hose Size3/8
Weight Lbs Per Ft0.094
IdentificationBlack Cover With Yellow Dot And Dash Stripe Running Parallel To Bore Of Hose To Indicate Natural Lay Of Hose After Installing. The Letters Lp In The Stripe Indicate Low Pressure. The Specificat
Id In0.375
Max Od In0.625
Max Working Pressure150
Mil Spec Mil-Dtl-5593
Min Bend Radius 2
Min Burst Pressure1
Operating Systems A. Severe Vibrating And Flexing. B. Resistant To Engine Oil And Cleaning Solvent Externally. C. Internal And External Temperatures From -67ºf To +158ºf. D. Internal Fluids
Proof Test Pressure Psi300
Size No06
NotesDimensional Information Is For Reference Only. Variations From These Dimensions On Actual Parts May Occur As The Result Of Engineering Revisions.